Tips And Tricks On Doing Your Own Plumbing

Did you know that loose pipes might be responsible for the hammering sounds in your plumbing? If this interests you, you might wish to check out all of the other great information in this article. Take a few minutes and learn all you can learn about plumbing today.

If a pipe ever freezes, you need to make sure to shut off the water. This will keep the pipe from bursting and causing you major damage to your home. Make sure to shut the water off at the main valve, and then open the faucet that is closest to the frozen pipe so it can drain while it is thawing out.

Roots from a tree in your back yard can be a real headache when it comes to plumbing. Make sure if you have a big tree or bush or some kind of plant with a big root system, that you ask your plumbing company about root killing agents. You can flush these down your toilet and kill any roots that may be blocking your pipes and save yourself a lot of money by stopping a back up before it happens.

When starting a plumbing project that is due to loud noises in your pipes empty the pipes first. This can be an easy fix to an other wise wasted huge job. Just close the main water line and open the facets throughout the house. After the water has stopped flowing turn the water on from the main source and check to see if the noise is eliminated.

If your house uses well water and there are orange or pink stains in tubs or sinks, it’s because of the iron level in the water. Luckily, you can quickly fix this by adding some water softener to your supply. You can pick up this product at a lot of stores, or have it shipped out to you.

Maintain smooth functioning of the drain in your bathtub by dropping baking soda and then vinegar down it on a monthly basis. Plug the drain afterwards or cover it with a washcloth, as the two chemicals are going to react with each other. Allow some time to pass, then follow up by pouring down boiling hot water. Doing this will help rid your pipes of disgusting soap scum and blockages.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

In conclusion, there could be simple or difficult reasons for problems with your plumbing. Those scary noises from your basement might just be from something as simple as loose pipes. Use the great advice provided here so that you can identify and resolve all of your plumbing issues.